|
Originally Posted by klausk
|
Hi, folks,
I tried to apply these reg settings because I ended up with the RNDIS problem.  But it does not allow me to rename the serial8 to serial6. I can change any registry settings, but NOT rename a key...  I get the "Error... Access is denied" message with no clue why.
Any hints?
Thanks,
klausk
|
There is a change under the registry key as well as the key name. I changed the stuff under the key first then changed the name of the key. That worked for me. I also didn't have anything paired to the device at the time, it was a fresh install of the BT stack.
Don't forget, I'm sure your already doing it, make backups. I cannot stress this enough. I have relied on mine a lot through this matter.
Hope this helps.
Michael.