|
Originally Posted by Malkavian
|
There is a change under the registry key as well as the key name. I changed the stuff under the key first then changed the name of the key. That worked for me. I also didn't have anything paired to the device at the time, it was a fresh install of the BT stack.
Don't forget, I'm sure your already doing it, make backups. I cannot stress this enough. I have relied on mine a lot through this matter.
Hope this helps.
Michael.
|
Hi, Michael,
I did a hard reset, uploaded the PHM Registry Editor and the Widcomm BT stack. The BT stack was installed on the "device" followed by a soft reset.
Next I brought up the registry editor and tried to change the name of the key. No luck. It doesn't matter if I change first the value data or try to rename. It results in the error.
The thing is that synching actually works after a soft reset and switching the RNDIS off even without changing the name, but the GPS is all confused because it wants to use one of these ports as well and it works over the BT. The GPS works fine until I start playing with the registry.
Grrr, I'm feeling like I have Windows 3.11 again.... :bang: Help would be most appreciated. (see frustration? :))
Thanks,
klausk
Follow up:
synching works if I change all settings for Serial8 to look like it's Serial6 even without renaming the key itself.
GPS works if I change all settings for the Serial8 back to the original settings...
Soft reset is required after the registry changes.
Obviously this is not what I'm looking for but it will do for a couple of days until I figure out what to do...