Mobility Site - View Single Post

mccorma · 09-21-03, 05:12 PM

Thanks for the in-depth explanation. One problem though, when set to "repeater" mode, the DWL-800 does not allow the selection of the channel. If you configure it as an access point, it does.

I did, however, change my router channel to 11 (one of those not shared). When I did this, the DWL-800 immediately showed the change to channel 11, as did my two laptops.

Not sure if that will make any difference or not, but performance does not really seem to be an issue--- I am more concerned with adequate signal strength in the lower level of my home/deck that maintains good performance and I think I have accomplished that.

09-21-03, 05:12 PM	#6 (permalink)
mccorma Aximsite Rookie Join Date: Jul 2003 Location: Georgia, USA Posts: 54 Thanked 0 Times in 0 Posts	Thanks for the in-depth explanation. One problem though, when set to "repeater" mode, the DWL-800 does not allow the selection of the channel. If you configure it as an access point, it does. I did, however, change my router channel to 11 (one of those not shared). When I did this, the DWL-800 immediately showed the change to channel 11, as did my two laptops. Not sure if that will make any difference or not, but performance does not really seem to be an issue--- I am more concerned with adequate signal strength in the lower level of my home/deck that maintains good performance and I think I have accomplished that.