Mobility Site - View Single Post

AlphaWolf · 09-22-03, 03:42 PM

dougprocter,

Thank you for your response. I've tried Sieko support a few times, but I end up on hold for over a half hour.

Anyway, in Windows, I did:
Start/Settings/Connections/Beam

and unchecked the "Receive all incoming beams" box. That's the only box I see under Beams.

In InkNote Manager, I hit:
Setup/Tablet Properties

I selected all the COM ports with no luck.

How do you have the other boxes set up? I have:
Tablet active - unchecked
Enable tablet only in InkNoteMgr - checked
Use tablet as kybd in other apps - unchecked

I also get a "You must make the pen active before testing" message when I try to test. I put in new batteries in both the pen and the SmartPad, too.

Were there any other settings changed?

Thanks,
AW

09-22-03, 03:42 PM	#6 (permalink)
AlphaWolf Aximsite Rookie Join Date: Apr 2003 Posts: 69 Thanked 0 Times in 0 Posts	dougprocter, Thank you for your response. I've tried Sieko support a few times, but I end up on hold for over a half hour. Anyway, in Windows, I did: Start/Settings/Connections/Beam and unchecked the "Receive all incoming beams" box. That's the only box I see under Beams. In InkNote Manager, I hit: Setup/Tablet Properties I selected all the COM ports with no luck. How do you have the other boxes set up? I have: Tablet active - unchecked Enable tablet only in InkNoteMgr - checked Use tablet as kybd in other apps - unchecked I also get a "You must make the pen active before testing" message when I try to test. I put in new batteries in both the pen and the SmartPad, too. Were there any other settings changed? Thanks, AW __________________ Dell Axim 5 256MB SD card/1 GB CF Card/Dell Keyboard/Rhinoskin case/VEO Camera RIP - Casio E-125