Mobility Site - View Single Post

gsteinb88 · 01-29-04, 07:54 PM

Hey all, not a newbie, but this seemed like the best place 2 post something as stupid as this. I have an Axim x5 basic running ppc 2k2. I dont think i have synced this one b4 except with ir to my laptop. This takes for ever and i decided to go back to the cord that i used with the axim that dell replaced (screen stopped workin for sum reason, wouldnt advise running aim on ur axim, i htink thats what caused it) Every thing runs fine up until the point where it is checking for changes. Then it acts as if the axim was pulled out and says that the axim is no longer connected. I have tried both the original active sync that came with it and the new 3.7.1. I have even tried it on both my desktop and laptop and have tried rebooting all 3, my desktop, my laptop and my axim. I have gone thru the install a couple times on each. Thanks a bunch, I just cant figure this one out.

01-29-04, 07:54 PM	#1 (permalink)
gsteinb88 Aximsite Veteran Uber Member Join Date: Sep 2003 Location: Boston, MA Posts: 1,887 Thanked 0 Times in 0 Posts	Active sync fails, need help Hey all, not a newbie, but this seemed like the best place 2 post something as stupid as this. I have an Axim x5 basic running ppc 2k2. I dont think i have synced this one b4 except with ir to my laptop. This takes for ever and i decided to go back to the cord that i used with the axim that dell replaced (screen stopped workin for sum reason, wouldnt advise running aim on ur axim, i htink thats what caused it) Every thing runs fine up until the point where it is checking for changes. Then it acts as if the axim was pulled out and says that the axim is no longer connected. I have tried both the original active sync that came with it and the new 3.7.1. I have even tried it on both my desktop and laptop and have tried rebooting all 3, my desktop, my laptop and my axim. I have gone thru the install a couple times on each. Thanks a bunch, I just cant figure this one out.