|
Orti
It does work... I did it about 10 times before I could get the motions right. I did it in this order:
1. Hold the stylus in your left hand, and tilt the Axim to your right, so the power (the little green/red button) is to the right.
2. Position your fingers thusly: Left index finger on the TOP of the stylus and middle finger positioning tip of stylus against the reset button, and left thumb on the Contacts button (make sure it is the Contacts button). Next Right thumb on power button and right index finger on the Scroller.
3. At the same time, push in the reset and power, then the contacts and the scroller. You literally push the scroller into the Axim.
4. Release the Stylus (i let it fall on my desk) and the power button at the same time, BUT HOLD THE CONTACTS AND SCROLLER IN FOR 20 SECONDS. This is crucial. It will work. You will get a white screen.
Best of luck...i am doing the same thing...i have to get a CF card reader tomorrow to make this work.
Rich
__________________
I got uh Axim X5 Basic 32Mb
I made it go from 300Mhz --> 400Mhz
Now it's WM2003
And I got these: 128/256Mb CF | 128Mb SD
|