Has there been any progress on the pinout over the weekend?
I have found on the Haicom website a diagram showing what pins go to where on the GPS PS/2 cable coming from the receiver , SO I know that end, just need to know where to solder them to on the x50v connector!
Haicom Diagrams
It's only 4 pins to solder! This would be cake if only we knew what pins were RX and what pins ere TX.
from what we currently know about the VGA cable :
|
Code:
|
i got this information from NickM_ (thanks!). it can be obtained from any official VGA cable, i don't see any reason why not to make it public.
----------------------------
No hardware at all.
Pin out (preliminary)
Pin# x50v Label Function
1 33 RED Red color signal
2 35 GREEN Green color signal
3 31 BLUE Blue color signal
4 ID2 Monitor identification bit 2
5 N.C. Not Connected
6 34 GND-RED Ground Red signal
7 36 GND-GREEN Ground Green signal
8 32 GND-BLUE Ground Blue signal
9 N.C. Not Connected
10 30 GND-SYNC Ground Sync signal
11 ID1 Monitor identification bit 1
12 26 ID0 Monitor identification bit 0
13 28 H-SYNC Horizontal Synchronization
14 29 V-SYNC Vertical Synchronization
15 N.C. Not connected |
Pins 30,32,34,36 all seem to be ground. So Pin 1 from the gps PS/2 can go to any of these.
Pin 2 on GPS PS/2 is VCC (i'm guessing to charge the unit via PS/2?)
We need which pins on axim connector are TX, RX, and VCC.
If anyone has ANY further info or corrections on what we have so far PLEASE post or PM me if afraid to post it!