Mobility Site - View Single Post

Rockwell108 · 06-27-05, 12:06 PM

then to make your cable you rould need two 3.5mm male jacks with three bands and cross a few wires the tip should be crossed to the band below it. this will allow the cable to be inserted either way and still work. the base should stay the same

YOU NEED TWO OF THESE

[II]
[II]
AA
AA
--
BB
--
\/

AA = BASE/COMMON \/ = TIP/HEADPHONE BB = MICROPHONE -- = BLACK BANDS

WIRE AA TO AA

WIRE \/ TO BB

WIRE BB TO \/

I'm assuming this wil work in wiring them together but I dont know if the axim will support streamig of the mirophone input...

06-27-05, 12:06 PM	#4 (permalink)
Rockwell108 Aximsite Minor League Join Date: Mar 2005 Posts: 142 iTrader Rating: (0) Thanks: 0 Thanked 0 Times in 0 Posts View MyPDA	then to make your cable you rould need two 3.5mm male jacks with three bands and cross a few wires the tip should be crossed to the band below it. this will allow the cable to be inserted either way and still work. the base should stay the same YOU NEED TWO OF THESE [II] [II] AA AA -- BB -- \/ AA = BASE/COMMON \/ = TIP/HEADPHONE BB = MICROPHONE -- = BLACK BANDS WIRE AA TO AA WIRE \/ TO BB WIRE BB TO \/ I'm assuming this wil work in wiring them together but I dont know if the axim will support streamig of the mirophone input... Last edited by Rockwell108 : 06-27-05 at 12:09 PM.