Mobility Site - View Single Post

DarkyX · 11-29-05, 09:35 AM

I installed Pulse Interactive Quake Mobile.
Installation was a breeze. However when starting up the game it changes to Landscape mode (Normal) Shows the Quake White Screen (Normal). Then it quits (Not Normal).

I then googled and searched and installed
"X50v Enhanced GAPI v 1.11"

In Settings Enhanced Driver Selected. XScale LCD Controller Selected. Then applied and then I did a soft reset.

since I am new to this. A soft reset to me is using the stylus to push down that little button on the back which restarted my dell axim x50v.

I read on some forums it might help going into the power settings for the CPU and set it to maximize. I did this restarted and tried Quake and same thing.

I checked the CF card where I installed it to make sure the files are actually there and they are 59 megs are in use. and the pak files are there and the .exe

Anything else I could be doing wrong?

11-29-05, 09:35 AM	#1 (permalink)
DarkyX Aximsite Minor League Join Date: Nov 2005 Location: Los Angeles, CA Posts: 111 Thanked 0 Times in 0 Posts	Pulse Interactive Quake Mobile I installed Pulse Interactive Quake Mobile. Installation was a breeze. However when starting up the game it changes to Landscape mode (Normal) Shows the Quake White Screen (Normal). Then it quits (Not Normal). I then googled and searched and installed "X50v Enhanced GAPI v 1.11" In Settings Enhanced Driver Selected. XScale LCD Controller Selected. Then applied and then I did a soft reset. since I am new to this. A soft reset to me is using the stylus to push down that little button on the back which restarted my dell axim x50v. I read on some forums it might help going into the power settings for the CPU and set it to maximize. I did this restarted and tried Quake and same thing. I checked the CF card where I installed it to make sure the files are actually there and they are 59 megs are in use. and the pak files are there and the .exe Anything else I could be doing wrong?