jxitco

I am new to this forum and in need of help. I purchased the Stowaway XT Ultra thin keyboard w/ iPAQ connector to use w/ my iPAQ 5555. The problems is that when I install keyboard program/driver into my iPAQ I am no longer able to turn it on using the power button. As a result I have to do a soft reset every time I want to turn on my iPAQ, which in turn causes my battery to drain over night because apparently it is not shutting down properly. I know this is all due to your software because when I delete if from my iPAQ everything works correctly.

Does anyone have any suggestions, so far Think Outside hasn't been too helpful.

Thank so much...

ikehiker

This sounds like the situation that occurred with the Axim X5 when people upgraded to WM03 but tried using keyboard drivers for PPC02. It was solved with new drivers. Have you checked the manufacturer's web site for new drivers?

__________________
-Ike-

jxitco

Once I realized the problem was with the Stowaway keyboard I did try this and it didn't help. Out of desperation I'll try it again.

thanks -
jdx

bbcole2

Originally Posted by jxitco

I am new to this forum and in need of help. I purchased the Stowaway XT Ultra thin keyboard w/ iPAQ connector to use w/ my iPAQ 5555. The problems is that when I install keyboard program/driver into my iPAQ I am no longer able to turn it on using the power button. As a result I have to do a soft reset every time I want to turn on my iPAQ, which in turn causes my battery to drain over night because apparently it is not shutting down properly. I know this is all due to your software because when I delete if from my iPAQ everything works correctly. Does anyone have any suggestions, so far Think Outside hasn't been too helpful. Thank so much...

I just installed the new drivers from
http://www.thinkoutside.com/support/Drivers.asp
and my button works now.
Bonnie