justbecause

HELP!!!!!!!!!!!!!
My USB doesn't work,

It just say unrecognized device

I cant sync with it

I can sync over the COM Port (SLOW)
I can sync over the WiFi (To Much Work)

anyone expericnce the same problem how did you fix it???

next thing the IPAQ always locking up won't turn on or
if I reset wont pass the booting screen

thanks

rob1303

Originally Posted by justbecause

HELP!!!!!!!!!!!!! My USB doesn't work, It just say unrecognized device I cant sync with it I can sync over the COM Port (SLOW) I can sync over the WiFi (To Much Work) anyone expericnce the same problem how did you fix it??? next thing the IPAQ always locking up won't turn on or if I reset wont pass the booting screen thanks

Hi justbecause - welcome to the site

You have a number of issues here.

Is your iPaq currently working? as you say it won't get past the boot-up screen - until you/ we can get it working there is little point in trying to answer the other questions.

__________________
Regards

Rob

justbecause

Originally Posted by rob1303

Hi justbecause - welcome to the site You have a number of issues here. Is your iPaq currently working? as you say it won't get past the boot-up screen - until you/ we can get it working there is little point in trying to answer the other questions.

well I hard reset it and it fine now just lost my data
but my USB connection is not functioning, SERIAL works

rob1303

Originally Posted by justbecause

well I hard reset it and it fine now just lost my data but my USB connection is not functioning, SERIAL works

Okay so you have your ipaq working

Let's try and get the cradle working now.

As you are in a 'clean' position on your iPaq we should start AS from a clean position.

I would recommend uninstalling activesync - Control panel> add/ remove programs and uninstall Activesync

Then go to C:\program files\ and delete the Activesync directory.

Unplug the cradle.

Go into Control Panel>System>Device Manager> and remove any entries with a yellow question mark.

Reboot your PC

Perform a soft reset of your iPaq

Install Activesync and follow the instructions.

Plug-in the cradle (without the PPC in it) - let windows find the new hardware

When on the blank Desktop place your iPaq in the cradle and follow the wizard.

Also do you have another USB port on your PC (do not use a hub) that you can try it on?

Hope this helps.

__________________
Regards

Rob

mikesus

When you get usb device not recognized it is one of two problems. Either active sync is improperly installed, or you have a bad button board (board inside ipaq that has the connector, these seem to go bad easily if you are not careful with the connector)