Silikon21

Hi!
I've broken my screen, I have accidentaly hw reset it and now I cannot pass the calibration screen because I dont' see where I should press the screen!
Could someone guide me troug screens ?

OSystem is WM2003

Best regards!

__________________
My collection of ipaqs: h3630,h3950,h5550,h2210
:)

imported_Radimus

I'd go with:
1) throw it in the trash
2) buy a new device (even a used or refurb one)


fighting a device with a broken screen is just going to be a constant frustration. Cut your losses and invest in a new one

__________________
Rad's Law on Technology
#1: All devices should charge via USB (where possible)
#2: All devices should have more than one function or interface with other devices
#3: LEDs are at least 50% too bright and should only be lit when an error is present, searching, or charging

MyPDA @ 01-08-07

Silikon21

I have invested in a new display 70 USD + 30 USD for shipping :)

'Till the new display arrives I'm trying to set up the device to use via remote desktop on the PC, but to do that I need to connect the device via activesync and I need to get past the calibration screen!!!!

BR

__________________
My collection of ipaqs: h3630,h3950,h5550,h2210
:)

ddehaan2

I cannot quite recall the order and process for calibrating the screen - but if the screen is broken then more than likely the receptors for the calibration process are not going to work for you anyway. I think that the first location is the center - next to the upper left - lower right - upper right then lower left. Even if you get close (and it recognizes the touch) it should let you pass - guess it just depends on how badly broken the screen is.

Good luck!

__________________
David DeHaan II
________________________
"forgotten more than I can remember now"

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


MyPDA updated 12/24/05