The definitive solution to getting microdrives out of your Ax without tape!
Just use pliers. I take out my SD and use the pliers. Believe it or not, it actually damages less than fingernails. No marks left! (unless I jerk by accident and it rips a piece of the plastic off :)) But this is working for me now, and its ok because I dont take it out often.
Directions for the micro drive state not to put pressure on the sides of the drive. Also I do not happen to carry plyers with me in case I wish to remove the drive. Tape is a much safer method IMHO.
That sounds like living on the edge to me, also. I much prefer to use the tape and slide the end down behind the Ax inside my case (so it can't be seen). When I need to remove the drive, like to add MORE MOVIES (I have about 15 full length movies now) I just use my stylus to pop up the end of the tape and lightly pull to remove it SAFELY! I'm sure you can use the pliers, but it seems more work to do it than with tape, IMHO.
I just rap mine sharply against the desk's surface. It usually pops out far enough to pry the rest of the way aut with a pocket knife.
(X)
p.s. Shouldn't this be in the "What Not To Tell A Newbie" thread?
i tried that with my dentures and the top plate came out and now my five year old grandson looks at me like i am some kinda of a monster!
I prefer to submerse my Axim into a cup full of liquid nitrogen. Since the metal contracts more below -170 F, when I pull the Axim out, my 8Gb MD practically falls right out.
So easy everyone should try it a couple times a week.
Kemo
__________________
Dell Axim x50v
ROM A05
Innopocket Magnesium Case
8Gb MD / 1 GB SD
Arkon GPS NAV Cradle & i-Blue High Sensitivity Bluetooth GPS
Boxwave HiPower Car Adapter
Pelican Power Brick (from GameStop)
Anycom BSH-100 BT Stereo Headset :approve: