Cisco Aironet PCMCIA card In CF Adapter

jasonmb · 03-05-03, 07:55 AM

Somebody in another forum had posted this link :

http://www.semsons.com/comflastopcc.html

Its a cf adapter that accomodates a pcmcia card. My question is, will this work with the axim, they make warnings about voltages and so on.

Also.. I have a cisco aironet pcmcia card. How will I get software to run the card for pocket pc? I dont see anything on the cisco web site ?? Any thoughts? Clues?

Thanks!

matefrio · 03-05-03, 11:10 AM

I will let you know next week as I have ordered one of these with my new Axim. I have heard that it does work even with LEAP enabled. Look at the forums on www.netstumbler.com there are a few there using this setup.

macjbraun · 08-25-03, 08:32 AM

The aironet software works fine in pocketpc 2002. I have been using it in my IPAQ for quite a while. The aironet 350 is a 5 volt device and draws 600ma. Based upon the specs of cf slots of 3.3v and 500ma I wouldn't put this in my axim unless you did it first.