Prism driver configuration

kark_1999 · 03-06-03, 03:18 PM

Ok, after a hard reset, I have been able to install the Prism driver and it DOES recognize my card. However, my card is flashing and I don't know what to put in the configurations.

Profile Name: Default
Network Name: PRISM-SSID
Network Type: Access Point

On the "Link" tab...

State: Associating

and it states that the Link Quality and Signal Strength = "Not Connected".

All the while, my green light on my CF card is blinking. Did anyone have to change any configurations?
Thanks.

JakeRich · 03-06-03, 04:54 PM

Change the Network Name to the SSID of the router to which you are attempting to connect. If you are Ad-hoc, then change the Network Type from Access Point to Peer-to-Peer and enter the channel.

kark_1999 · 03-06-03, 05:55 PM

Quote:

Originally posted by JakeRich
Change the Network Name to the SSID of the router to which you are attempting to connect. If you are Ad-hoc, then change the Network Type from Access Point to Peer-to-Peer and enter the channel.

That was too easy. Thanks (I'm wearing a dunce hat). Anyway, I'm up and running!