Here are the steps for setting up the messaging if you decide to go that route. Good Luck~
Open the messaging program (Start-> Messaging)
Select Accounts->New account
E-Mail Setup (1/4)
E-Mail address
Enter email address: Here you enter your full email address (ie
RockStar@InsightBB.com)
NEXT
E-Mail Setup (2/4)
User Information
Your Name: Enter your name
User Name: Enter your username (the part before the @ in your email address)
Password: Enter your email password
Check the box for “Save Password”
NEXT
E-Mail Setup (3/4)
Account Information
Account type: Select POP3
Name: You can choose any name you would like to identify this account on your Axim
NEXT
E-Mail Setup (4/4)
Server Information
Incoming mail: put in ~ mail.insightbb.com
Outgoing mail: put in ~ mail.insightbb.com
Domain: leave blank
OPTIONS
Options (1/3)
Here I would NOT check the box to connect and check for messages every X# of minutes because if you do not have your wifi on and receiving a signal you will get an error message every X# of minutes.
Connection: Set to ~ Internet
NEXT
Options (2/3)
Check the boxes on this page for “Outgoing mail requires authentication” and also the box for “Use separate settings”
OUTGOING SETTINGS
Outgoing Server Settings
Username: Enter your ENTIRE email address (ie
RockStar@insightbb.com)
Password: Enter your email password
Domain: Leave blank
Check box for “Save Password” and also check the box for “Require SSL for outgoing mail”
OK – upper right corner
NEXT
Options (3/3)
Pull down menu should be set to “Get message headers only”
Check box for “include” and it should say “2 k”
FINISH
Turn on your WiFi and connect.
Click accounts and select the account you just created, then click the send/receive button (two envelopes) and test it out.
