I've got an Axim X51v and I was, until recently, happily using Transcriber. However, when I went to use it the other day, I got the following error:

"Transcriber's touch handler is not installed. Did you reset your PPC by pressing "reset" hidden button after installation?"

I've tried looking on the CD that came with my Axim but there's nothing on there with which I can reinstall the transcriber software. I've tried to find out the version number that's installed but to no avail, it just keeps crashing and asking me if I'd like to send the error message to Microsoft (GRRR!!!!).
I've tried installing version 1.51 off the Microsoft website (even though it says CE 2002) but after going through all the steps of the installer, nothing appears to have happened - it didn't pop up Active Sync and certainly nothing appeared to install on my axim.

Can anyone help me work out how to get it back?

I've never had any problems using it up until this so I'm not after suggestions of "replacements" (especially ones that cost money!), I'm just after advice on how to get Transcriber back up and running again.

Thanks!
- BK.

Anyone? Anyone at all??