Broadcom BT stack and Dial-Up Networking SEVERE ISSUE!

Unit ZER0 · 09-28-07, 12:40 PM

I just installed Mikelspikel's Broadcom BT stack, and it is loads better that the default BT stack on my Axim X51v. But, I was able to use the dial-up-networking feature for only three days, and now I cannot use my cellphone as a modem anymore. I tried uninstalling the stack, and using the default BT setup. I was unsuccessful. Prior to installing the Broadcom setup, I was able to use my cellphone to dial into the Internet. But now, no matter which stack I use, I am unable to connect. The error message I recieve is as follows: Unable to connec for an unknown reason, if this problem persists, reset your device according to the manufacturers specifications. This occurs after I attempt to connect to my cellphone and use it as a modem. I can still pair with it, and even browse and transfer files to and from it, but I cannot use it as a modem anymore. Any assistance would be greatly appreciated.

speedy1979 · 09-28-07, 04:29 PM

You signature indicates that you have a Samsung SGH T809 with T-mobile. Is that still correct.

I don't know much about T-mobile. But I also use my Phone as a modem on Sprint to provide Web access for my X51V using the Broadcomm stack.

Inorder to access the web you have to log-in using your Vision username and passcode with Sprint. I am assuming that T-mobile has an analogous procedure.

Prehaps your T-Zones passcode and username.

Unit ZER0 · 09-29-07, 12:47 AM

Corect, I still own my SGH T809, but I have been able to dial in in the past without entering any such T-Zones username or password. The phone treats the modem dial-in as any other phone call, I am dialing into a land-based phone line. In any event, I am not even able to get to the dialing-in step, the PDA connects to the phone, then flashes the error: Connection lost, unable to reconnect. I cannot even get to the step where the phone begins it's dial out procedure.