13walker

Friends,

I've been using a Rhinoskin aluminum case for some time with no issue, when all of a sudden today, the case detached from the belt clip, causing the case with PDA inside to land on the hard floor. (I guess it's broken in now!) Luckily, the Rhinoskin did it's job, and protected the PDA, as it was fine.

So now I'm wondering, how do I get the belt clip back on correctly? I basically turn the belt clip several times which seems to screw it back into the case, but I've had it pop off additional times today since doing that. There doesn't seem to be a good way to get it securely re-attached, like it was the first couple of months that I used it.

Has anyone else run into this?

Thanks!

laprob

You will have to go at saunders site and order another plastic belt clip, the problem is the belt clip it's in plastic rather than aluminum.

I am tryng to find a aluminum belt clip that will last rather than the plastic one.

tiger_splash

Originally Posted by laprob

You will have to go at saunders site and order another plastic belt clip, the problem is the belt clip it's in plastic rather than aluminum. I am tryng to find a aluminum belt clip that will last rather than the plastic one.

I just had the same thing happen. The clip is part of the case and as such is under warranty.

Mine broke and dropped my PDA in the middle of the road . I wrote Saunders and they sent me a replacement for free. I am using it now and it is holding well if not better.

YodaEXE

Also, you could try adding some super glue or something to the place the clip connects to the case. That will help a little bit hopefully.

13walker

Cool, thanks for all of the great suggestions! I think I will try and get a replacement, and try the super glue trick in the mean time.