WiFiFoFum

flyingwil · 01-12-05, 06:11 PM

Hi-
I just recently downloaded and installed WiFiFoFum and have no clue as to how to set it up to get it to work can any one help... I need help like from step one!

Thanks!
Wil

Howard2k · 01-12-05, 06:27 PM

Did you install it on the PPC? What happens when you try to execute it? Did the install fail?

01-12-05, 06:43 PM

I believe WiFiFoFum is one of those apps where you simply copy the executable to a folder on your Axim, then create a shortcut to the file. There is no installer for the program . . .

dmorley00 · 01-12-05, 07:10 PM

Well, first thing's first; (Have Wifi on and Open up Wififofum), click on Tools>>Device>>tap ODIM\WLAGS46B1.

I have Wififofum on my X30H, and it seems to work properly. My question refers to streethawk. It just gives me an erroneous search loop. "Waiting on WZC to be free." What does that mean? EDIT: Nuts. Read the wififofum forum on streethawk. WZC = Wireless Zero Config.

supergper · 01-13-05, 01:45 AM

I would strongly suggest Ministumbler over WiFiFoFum...

flyingwil · 01-13-05, 11:59 AM

Originally Posted by dmorley00

Well, first thing's first; (Have Wifi on and Open up Wififofum), click on Tools>>Device>>tap ODIM\WLAGS46B1.

I have Wififofum on my X30H, and it seems to work properly. My question refers to streethawk. It just gives me an erroneous search loop. "Waiting on WZC to be free." What does that mean? EDIT: Nuts. Read the wififofum forum on streethawk. WZC = Wireless Zero Config.

Thank you that was what I was looking for!!!!

VidProducer · 01-19-05, 05:36 PM

Originally Posted by supergper

I would strongly suggest Ministumbler over WiFiFoFum...

So far, my searches have resulted in messages that say Ministumbler does not work with the internal WiFi card in the X50v - have you other info? Thx

crazycanuck · 01-30-05, 06:42 AM

I have tried wififofum with the x50v, and when I open the .exe I get 'default settings being used....settings saved on exit' and have no idea now what to do. I had wifi enabled first, all the files from program .zip were copied to the ppc folder. Nothing seems to happen. I get a grey chart with some titles at the top, but no graph,chart,radar or ??. Tried playing with the options for device etc...no luck.

I guess I will keep looking. :realmad:

albaris · 01-30-05, 07:12 AM

I found that after installing WiFiFoFum, I had to do a soft reset. Then turn on the WiFi, and run WiFiFoFum. It read the network card, and gave me the readings.

When you first start WiFiFoFum you will get that message 'default settings being used....settings saved on exit'. Just click OK at the right top corner. It is just telling you what will happen when you exit the program.