HELP!!! Just in Time debugging error?!?!

[mcclutz]

[/B][B]Every time I turn on my Axim, I get this error message pop-up. It says "Application filesys.exe has performed an illegal operation. Program: filesys.exe Exception: 0x80000002 Address: 0001ba64 Do you want to debug?"

Does anybody know why? I don't want to lose my data, so I don't want to hard reset.

Any help would be greatly appreciated.

Mcclutz

[Mike C]

As long as you have a backup that was made prior to the trouble, it's really painless to reset and restore.
I've never seen this problem, but whenever the x acts up, you reset.
First soft, then hard if necessary. That is the extent of my knowledge. It works when the files are not corrupted.

[TSB8C]

That type of error usually results from one of only two sources - a corrupt file ("filesys.exe") or a memory problem (the file attempted to use a block of ram that was bad or in use when it shouldn't have been). If the file loaded in memory is corrupt then a hard reset is the only way to clear it out and reload the original from ROM. If the memory location specified in the message is the problem, a soft reset should clear that (unless you have a hardware problem - bad memory chip). Hope you have a backup...