X50 unresponsive

co user · 10-09-09, 03:47 PM

I have an X50 that worked fine this morning. Then, I pulled it from the cradle today after syncing to an XP machine to which it has synced many times before and it was completely unresponsive. No buttons, including power worked, nor did the touch screen. It did go into power save and then powered off after a few minutes like normal. I soft booted a couple of times and it would power back on, reboot and come to the pin screen, but still would nto respond to touch or power button. I did a hard reboot and now it is stuck on the screen that says "To restore factory settings press XX. to cancel press XX. Restoring factory cetting will erase data." or something to that effect. Unfortunately, since none of the buttons work, I am stuck on that now.

Any ideas. Is it in a coma and I should pull the plug or is there hope. I don't care so much about the data on it, but I would like to get it functional again.

THX

Box · 10-09-09, 04:10 PM

Lock switch.

co user · 10-09-09, 04:57 PM

Holy cow, I am an idiot. In my panic thinking I had killed my Axim, I did not even check that. Thank you so much!