A02 eliminates Bluetooth stack.

capt_tast · 03-07-05, 10:13 AM

I flashed my ROM to the A02 WITHOUT A PROBLEM. After that my bluetooth keyboard isn't detected. I get a message that reads something about no bluetooth stack. I restored the old ROM and it works fine.
Any ideas?

I would like to upgrade the ROM(maybe?) but I would like to use my keyboard. I couldn't find any mention of bluetooth stacks on the website and I installed both sets of Dell drivers and the
Think Outside drivers.

Under A01, everything is running fine, so I may not upgrade it at all.

Akarui Kage · 03-08-05, 02:30 PM

I use a bluetooth keyboard with the A02 ROM update and everything works fine. Make sure that you installed the driver to the main memory, otherwise you will have problems. I'm also using ONLY the Think Outside driver. The ones offered from Dell are just... weird. Well, good luck! hope this helps :)

03-08-05, 05:52 PM

I had to use the "special" instructions to install the TO BT keyboard when I had the A01 ROM. If I restored a backup from the A01 while A02 is installed, then the keyboard worked fine. I want to do a complete wipe and reinstall everything because it seems my axim runs much faster and smoother. When I whipe it, I cannot get the drivers to find the BT stack. I have the same problem as before where I cannot detect any BT equipment on the keyboard BT tab. The "special" instructions aren't helping at all. Please help!!

TIA

cnycompguy · 03-09-05, 02:17 AM

i have the BT keyboard and A02, no problems here. try reinstalling the drivers.

capt_tast · 03-09-05, 12:22 PM

OK. So far so good. I installed the drivers from the think outside website. I used the drivers for the Axim x5. It must be a previously released. So far everything works GREAT.

03-09-05, 12:29 PM

cnycompguy, how did you install it to make it work? I tried turning off BT and WiFi and resetting it, but nothing is working. I keep getting the "BT device not detected" error in the status area.

Mona13 · 03-09-05, 09:31 PM

I had that same problem today. It was the first time I tried to use mine since I traded my A01 x50v with the A02 x50v. I had just installed it from the driver I had on my unit before. Didn't work. I had to go to the Think Outside site and get the new driver. I installed it to main memory. Then the first time it connected it asked me if I wanted to update and I chose yes. Took a few seconds, but then it worked great.

Mona13

integratee66 · 03-10-05, 12:54 AM

hey tast how did u restore A01 rom? when i tried it it gave me an error saying it has to be from original device, which it was.

03-10-05, 01:34 AM

Mona13, did you leave WiFi and BT enabled before installing the drivers?

Mona13 · 03-10-05, 08:44 PM

Both WiFi and Bluetooth were turned off. Just downloaded the most recent driver from the website.

Mona13