Clean X51v screen

Stick a bit of sticking tape in one corner of the protector and, pulling it, try to (gradually) lift off that corner off the screen.

LOL. Genious. Can't believe I didn't think of that.:approve:

Well I got 2 Clarivue screen protectors, cleaned the screen and applied one... but it looks like something's wrong, the screen protector seems to be too small (it is the oen they sell for the X51v). Dunno whether I did something wrong, but the screen protector doesn't seem to have adhered to the screen much, I can move it around with my finger... I tried pressing it down with a card (plastic, credit-card like) and all it did was royally scratch my screen protector. Right now it's just kinda half-adhered, it moves if I put my finger on it but not with the stylus.

What I'm wondering at is not that the screen protector didn't adhere properly (which probably was my fault), but that it seems too small. There are lips around the edge of the screen that it can slide into, so unless the screen protector is perfectly centered it won't cover the entire visible screen surface.

Yeah I was pretty frustrated that the screen protectors from Clarivue don't quite cover the whole screen...if you align the corner of the protector with the upper-left corner of the touch-screen you are left with a slight 'gap' where the screen protector doesn't cover on the bottom and on the right side....That's why i'm going to try and use tape to get it off, wash it, then re-apply (in a foggy bathroom cause that sounds high-tech). I'm to to align the protector at the upper-right corner instead so I can scroll normally again.